cplic print is also useful to get the list of the device mac addressĪs for the model itself, there are certain model need to be mapped according to what is being reflected on the dmiparse | grep ‘Product Name’ as below table. Check MAC address - sometimes it is needed to see MAC (Media Access Control) address of the PC or laptop and here's how to check MAC address of your network devices.ifconfig -a | grep ‘HWaddr’ -> to get the mac address (usually Mgmt port is used).dmiparse | grep ‘Serial Number’ -> to get the serial number.

dmiparse | grep ‘Product Name’ -> to get the model of the checkpoint device.

Hi Carl, I copied the Host ID from the right side of my screen and pasted this into the portal when I downloaded the licenses. In order to get the serial number of the Checkpoint device, one can go to the expert mode of checkpoint (login to ssh -> type ‘expert’) and type following command: Did you allocate the Gateway VPX license to the MAC address If you go to System > Licenses, click Add License, it should show you the MAC address on the right side of the screen. Introduction to system() function then explained with example. For example, if you create a VRID with a value of 60 and bind it to an interface, the resulting virtual MAC is 00:00:5e:00:01:3c, where 3c is the hex representation of the VRID.

The generic virtual MAC is of the form 00:00:5e:00:01:.

There are several ways to get Checkpoint serial number, mac address and model in order to either open a case with support or to get the information for archive purpose.įirst thing is the serial number. This tutorial demonstrate how to obtain mac address using c++. If there is no IPv4 virtual MAC bound to an interface, the interface’s physical MAC address is used.

How to check mac address of vpx